Ways to Winterize Your Irrigation System

During the winter months, most homeowners will tend to use their irrigation system less and less. This, however, does not mean that your irrigation system is free from water. There might be some water left on both the ground and underground components. The low temperatures of the winter months can cause havoc on these components even if water isn’t present. While using your system less in the winter is a natural cycle in taking care of your property, there are steps every homeowner should take to ensure their system is cared for properly and will not cause problems in below-freezing temperatures. The following includes a few ways to winterize your irrigation system.

Utilize Your Irrigation System Manual Valves

One of the best ways to ensure that there is no excess water present within your system during the winter months is to utilize the manual drainage valves. It is imperative that you first turn off the water supply to your system before opening the valves. In the event that you have a sprinkler system, then you may need to look for your check valves. Simply lift the sprinkler head and allow the water to drain out.

Blow-Out Method

If you have attempted the technique above and have not been able to remove all the water from your irrigation system, then using the blow-out method may be your best bet. It is crucial to take these steps to protect your property and appropriately care for your system. The blow-out method uses compressed air to blow out all remaining water from within. It should be noted that this is a very dangerous thing to do on your own. It may be safer to contact a professional. In this case, it is important to consult with a Las Vegas backyard landscaping company to ensure that this is done safely and properly.

Check out our photo gallery of past work HERE

Request a free estimate from Wet-Tec HERE

Share this post!